Rikard Johnels wrote:
I have an older Intel server with a Mylex RAID card in it.
The array is 6 drives in RAID 5, no spares.
The installer complains about not being able to do anything on the array, so i
got into a rescue kernel boot and used fdisk to make three parttitions on it.
/dev/rd/c0d0p1 - /boot (ext2)
/dev/rd/c0d0p2 - swap (swap)
/dev/rd/c0d0p3 - / (xfs)
I made the filesystems after syncing the disks.
But the installer doesn't recognize them at all.
It sees /dev/rd/c0d0 as a full partition, and states it cannot do anything
with it.
How do i get the table read?
How do i initialize the array for usage in the installer?
I am eagerly waiting for the answer as well because I suspect that I
currently have the same problem with an old FSC Primergy 470 with Mylex
DAC960PRL Controller.
Can you delete the partitions and create them in yast again? If not, I
can't update to Suse 10.2 either.
Sandy
--
List replies only please!
Please address PMs to: news-reply2 (@) japantest (.) homelinux (.) com
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
