Dňa Po 5. Február 2007 17:03 Peter Van Lone napísal: > On 2/5/07, Stanislav Visnovsky <[EMAIL PROTECTED]> wrote: > > Yes, control file is the XML file generated by AutoYaST or by the > > cloning at the end of the installation. > > that is very good, thank you. > > Now, one or two more "can it do this" questions, and if the answer is > yes, I'll go to the docs to figure out the HOW: > > 1)if I want to do a basic install, then set some environment values > perhaps, or add in a package or two that were forgotten in the > original install, can I create the autoyast.xml at this point so that > it captures these changes? (again, I don't want or need all the > complexity of an install source on the network, etc ... I just want to > be able to duplicate and automate a few installs using the xml file on > a floppy and the dvd installation method)
You can always edit the autoyast.xml file by hand. In fact, it was designed from the beginning to support hand-editting. > > 2)will this procedure still "identify" hardware? So, for example, if I > want an exact duplicate package selection and disk partitioning, but > the monitor is different, or the system board is different, etc ... > will the auto installs using autoyast.xml work for this? Yes. That's the real beauty of AutoYaST and also its curse. Because you need testing to see if everything went fine - just to warn you beforehand. Stano -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
