Hello,
In the Message;
Subject : [opensuse] 10.2 and SaX2 problem
Message-ID : <[EMAIL PROTECTED]>
Date & Time: Thu, 22 Feb 2007 23:20:20 -0500
[Carl] == Carl Hartung <[EMAIL PROTECTED]> has written:
Carl> Hi All,
Carl> Up through SUSE 9.3, SaX2 accepted the following configuration for my
on-board
Carl> graphics chip, SiS 630, and monitor, an NEC MultiSync 77F:
Carl> Monitor
Carl> display size: 325 x 244 mm, aspect ration 4:3
Carl> horizontal rate: 28 to 70 Khz
Carl> vertical rate: 54 to 120 Hz
Carl> colors: 8-bit, 16-bit (24-bit to 1280 x 1024; 32 bit to 1152 x 900)
Carl> --> 1600 x 1200 at 16-bit color was my preferred and default setting
[...]
Carl> seems to just ignore/reject them and they're overwritten to 1280 x 1024
at
Carl> 24-bit.
Because,
Carl> horizontal rate: 28 to 70 Khz
is too low for 1600x1200x24 bit. Set this;
horizsync 28 - 76 KHz
For this, the refresh rate becomes 60Hz.
In case of CRT display, the higher, the better.
So, set the maximum value of horizontal sysnc according with the display's
manual.
Regards.
---
Masaru Nomiya mail-to: nomiya @ galaxy.dti.ne.jp
"Bill! You married with Computers.
Not with Me!"
"No..., with money."
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
