On 6/5/07, Carlos F Lange <[EMAIL PROTECTED]> wrote:
I did that. I just assigned the usual IP number in Yast (along with subnet mask and gateway), but I still cannot ping the gateway or other machines in the LAN, nor is it seen by them.
Check if you have installed netdiag package. It contains mii-diag utility, which can produce more information about the card. You can use it as well to force it to use only 10 or 100 connection, etc. I had problems with a netwrok card, which could not negotiate correctly 100 mbps speed because of faulty cable, and I could make it run on 10 mbps, until I found out that the problem is with the cable, and I need to replace it. Cheers -- Svetoslav Milenov (Sunny) Even the most advanced equipment in the hands of the ignorant is just a pile of scrap. -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
