Detlef Reichelt wrote:
> Hi Chris,
>
>
> boot knoppix...
>
> Detlef
>
Detlef, i found that changing the adapter emulation mode from i20 to
mass storage would load the correct driver and the install would find
the RAID but then i get "failed to initialize catalogs" error. I have
tried to hook to the on-board SCSI connector and receive the same error.
I even have installed a separate SCSI card with the hot-swap drives
attached to that new card and get the same error. I then burnt new CD's
thinking something was wrong with the discs but get the same error with
new discs. Is there something else with the dell poweredge 4300 that i
should know about?
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
