Bryen wrote: > On Tue, 2007-12-04 at 09:06 -0600, Jim Flanagan wrote: > >> Jc Polanycia wrote: >> >>> On Tuesday 04 December 2007 06:46:03 Matthew Stringer wrote: >>> >>> >>>> On Tuesday 04 December 2007 12:48:46 Jim Flanagan wrote: >>>> >>>> >>>>> Hi, >>>>> >>>>> On my new 10.3 install I set up 2 drives in raid1 mirror, using >>>>> software raid in yast. All seems to be working fine except in >>>>> Kinfocenter>memory swap is shown as not available. Yast shows swap with >>>>> an "*" beside it. My partitions are set up as follows: >>>>> primary >>>>> /dev/md0 /boot >>>>> extended >>>>> /dev/md1 /swap >>>>> /dev/md2 / >>>>> /dev/md3 /home >>>>> /dev/md4 /share >>>>> >>>>> I'm not that familiar with tweaking swap and have only set it up in >>>>> yast>partitioner before with no previous problems. This is my first >>>>> raid setup so there may be an issue with that, but again, all others >>>>> partitions are working fine. I tried editing swap in yast to format it >>>>> again as /swap but it failed with an error code -3004. >>>>> >>>>> Anyone know what this problem may be? >>>>> >>>>> Many thanks, >>>>> >>>>> JIm F >>>>> >>>>> >>> Try running swapon -s and see if the device is listed. Also, >>> cat /proc/mdstat. Your swap device should show up in the swapon -s >>> command. It should show up in mdstat but may be listed as >>> (auto-read-only). >>> I had a similar issue on one of my hosts and ended up having to change >>> the >>> boot flags. I edited /boot/grub/menu.lst and changed the item >>> resume=/dev/md1 to noresume. This disables the ability to hibernate the >>> machine, but allowed my swap to work properly. >>> >>> Hope this helps. >>> >>> -jc >>> >>> >>> >> swapon -s shows one line like this.... >> Filename Type Size Use >> Priority >> >> with nothing else listed below. >> >> cat /proc/mdstat does show md1 as active (auto-read-only) >> >> Do you mean replace "resume=/dev/md1" with "noresume"? >> >> Also, while at this point I don't envision hibernating this machine, you >> never know. Is there a different fix without disabling hibernate? Will >> subsequent grub installs pick up this noresume flag? >> >> Many thanks, >> >> Jim F >> > What does the swap partition look like in /etc/fstab? > > You can type 'cat /etc/fstab | grep swap' and paste the results here. > > That returns...
/dev/md1 swap swap defaults 0 0 Thanks, Jim F -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
