Enable the log_whole_attack preferences in the config file, perhaps we may find an answer in openvassd.message log file.
On Thu, May 26, 2016 at 4:17 PM, Allyn Baskerville <[email protected]> wrote: > Yes, the port list does contain this port. I just did a tcpdump on the > host that was tested by the scanner, and the scanner pinged the host twice > and then generated the 3-way handshake to the obscure port, and then reset > the connection. There was no more traffic, and the scan was done. The > scanner performed no tests on this system. Here is the report results: > > > > 0 results > > Empty reports can happen for the following reasons: > > - The target hosts where regarded dead. > - The filter does not match any result. > - A very small or non-verbose scan configuration was applied. > > > <https://172.31.1.101:9392/omp?cmd=get_report_section&report_id=36b78077-58af-4d02-83a4-54b079556b69&report_section=hosts&result_hosts_only=0&token=923d481f-dca8-42c8-896d-5783c3e6122f> > > However, this report contains 1 host. > <https://172.31.1.101:9392/omp?cmd=get_report_section&report_id=36b78077-58af-4d02-83a4-54b079556b69&report_section=hosts&result_hosts_only=0&token=923d481f-dca8-42c8-896d-5783c3e6122f> > > > > > > *From:* Openvas-discuss [mailto: > [email protected]] *On Behalf Of *Sebastien > Aucouturier > *Sent:* Thursday, May 26, 2016 1:23 AM > *Cc:* [email protected] > *Subject:* Re: [Openvas-discuss] Having a problem scanning services on > nonstandard ports > > > > When you create your target config ? > > do the port lists attach contains this uncommon ports ? > > > > > > On Thu, May 26, 2016 at 1:21 AM, Allyn Baskerville <[email protected]> > wrote: > > Having just setup OpenVAS, I test scanned the local machine, and a couple > issues were noted. I tried to scan my server that is only listening on two > obscure ports, and I setup a port list with only these two ports in it, > bound it to a target (the IP of this host), and then I ran a “full and > fast” scan. The scan finishes very fast – about 2 minutes, and the report > comes back with no open ports, the severity shows N/A, the report shows “0 > results”, but it does show “However, this report contains 1 host.” I’m not > sure if nmap could be a problem, since running ./openvas-check-setup yield > the following: > > > > WARNING: Your version of nmap is not fully supported: 6.47 > > SUGGEST: You should install nmap 5.51 if you plan to use the nmap > NSE NVTs. > > > > I’ve seen various posts commenting on this, but I’ve not found a > resolution. Can anyone throw some ideas at me as to what I might try? Thanks > > > _______________________________________________ > Openvas-discuss mailing list > [email protected] > https://lists.wald.intevation.org/cgi-bin/mailman/listinfo/openvas-discuss > > >
_______________________________________________ Openvas-discuss mailing list [email protected] https://lists.wald.intevation.org/cgi-bin/mailman/listinfo/openvas-discuss
