Am Mittwoch, 7. September 2016, 17:08:01 schrieb Allyn Baskerville: > I'm trying to scan 6 hosts, and two of these hosts do not permit ICMP to > them. Scanning the other 4 hosts would complete within 2 hours, but the two > hosts that blocked ICMP were not scanned at all. I cloned the Full and Fast > scan configuration, and the only thing I changed was "Mark unreachable as > dead" from "Mark unreachable Hosts as dead (not scanning)" from no to yes, > "Do an ICMP ping" from yes to no, and "Do a TCP ping" from no to yes. All > hosts show up, but the scans now run for 3 days. Very little traffic is > generated to these hosts. Can someone point me to a way to optimize this? > I've been searching around for a solution, but no success so far.
not sure mark unreachable makes sense here. Perhaps "consider alive" is a better way? What you might want to do is to create separate targets, one with the simple hosts and one with the problematic. Then you can optimize for the problematic without affecting the scan of the other ones at the same time. -- Dr. Jan-Oliver Wagner | +49-541-335084-0 | http://www.greenbone.net/ Greenbone Networks GmbH, Neuer Graben 17, 49074 Osnabrück | AG Osnabrück, HR B 202460 Geschäftsführer: Lukas Grunwald, Dr. Jan-Oliver Wagner _______________________________________________ Openvas-discuss mailing list [email protected] https://lists.wald.intevation.org/cgi-bin/mailman/listinfo/openvas-discuss
