I lost some word... Hi All,
I rebased the patch on the last tr...@17618. I hope to see the external-toolchain patch in the main line. best regards, luigi On Sun, Sep 20, 2009 at 5:15 PM, Luigi Mantellini <[email protected]> wrote: > Hi All, > > I rebased the patch on the last tr...@17618 the external-toolchain > patch in the main line. > > best regards, > > luigi > > On Thu, Sep 10, 2009 at 12:56 AM, Luigi Mantellini > <[email protected]> wrote: >> Thanks :D >> >> On Thu, Sep 10, 2009 at 12:17 AM, Nico<[email protected]> wrote: >>> Hi Luigi, >>> >>> There were no particular reasons preventing external toolchain support >>> from hitting trunk apart from a constant lack of time on my side... >>> >>> I'll try my best to have it commited by the end of the week. >>> >>> Thanks for your help and support ! >>> >>> Regards, >>> -- >>> Nico >>> >>> >>> Luigi 'Comio' Mantellini wrote: >>>> Hi List, >>>> Hi Nico, >>>> >>>> find the attached my contribute. >>>> Starting from nico's patch I build this patchset that adds the ability to >>>> use >>>> use an external toolchain (rebased on r17459). >>>> >>>> I compiled a simple ppc440 target with and without the external toolchain >>>> usage and it seems to work fine. As external toolchain I used the >>>> CodeSourcery >>>> G++lite 4.3-50 for Power EABI >>>> (http://www.codesourcery.com/sgpp/lite/power/portal/release603). >>>> >>>> Find also the config.external and config.normal configs to look my board >>>> setup. >>>> >>>> My wish is to see this patch in the main-line as soon possible because is >>>> very >>>> important for my job. >>>> >>>> Any feedback is welcome. >>>> >>>> best regards, >>>> >>>> luigi >>>> >>>> >>>> >>>> Il domenica 6 settembre 2009 20:26:46 Luigi Mantellini ha scritto: >>>> >>>>> Hi List, >>>>> >>>>> as in the past I will ask again opinions regarding the optional >>>>> support for external cross-toolchain. >>>>> >>>>> Reading the dev.openwrt.org I see: >>>>> >>>>> "OpenWrt is currently being used in industrial control systems, small >>>>> robots, sensor networks, home control solutions, VoIP systems, both >>>>> wired and wireless networks and a whole lot more." >>>>> >>>>> I'm working on network devices and usually I receive from my vendors >>>>> the BSP and toolchain that is considered "official" and "safe" for the >>>>> BSP. My suppliers usually don't accent to support BSP (and anwser to >>>>> my questions) if I don't use the provided toolchain. >>>>> >>>>> From these considerations, My opinion is that external target-specific >>>>> toolchian should be supported by OpenWRT avoiding to compile everytime >>>>> the toolchain. >>>>> >>>>> In past Nico sent a set of patch for support this feature but I think >>>>> that are not included yet in the mainline. >>>>> >>>>> Nico, can you provide me your last patches? and explain if them will >>>>> be included or not? >>>>> >>>>> thanks in advance and best regards, >>>>> >>>>> luigi >>>>> >>>>> >>>> >>>> >>> >>> _______________________________________________ >>> openwrt-devel mailing list >>> [email protected] >>> https://lists.openwrt.org/mailman/listinfo/openwrt-devel >>> >> >> >> >> -- >> Luigi 'Comio' Mantellini >> R&D - Software >> Industrie Dial Face S.p.A. >> Via Canzo, 4 >> 20068 Peschiera Borromeo (MI), Italy >> >> Tel.: +39 02 5167 2813 >> Fax: +39 02 5167 2459 >> web: www.idf-hit.com >> mail: [email protected] >> > > > > -- > Luigi 'Comio' Mantellini > R&D - Software > Industrie Dial Face S.p.A. > Via Canzo, 4 > 20068 Peschiera Borromeo (MI), Italy > > Tel.: +39 02 5167 2813 > Fax: +39 02 5167 2459 > web: www.idf-hit.com > mail: [email protected] > -- Luigi 'Comio' Mantellini R&D - Software Industrie Dial Face S.p.A. Via Canzo, 4 20068 Peschiera Borromeo (MI), Italy Tel.: +39 02 5167 2813 Fax: +39 02 5167 2459 web: www.idf-hit.com mail: [email protected] _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
