I've tested this with ramips board. Of cause device should be registered but it's intended to be selected automatically via target board profiling. For now it should be selected manually. Without this you'll have to say RTL8366RB/S_PHY=y in target kernel config which will be applied to all boards what is useless because not all boards have these switches.
Regards, Roman On 29 September 2010 15:04, Jonas Gorski <[email protected]> wrote: > Hi > > On 29 September 2010 13:22, Roman Yeryomin <[email protected]> wrote: >> Add rtl8366 switch kernel packages so that they could be selected if a >> user has board with such switch. > > I do not think this will work for most targets. The last time I tried, > phy devices are only probed on ethernet device driver registration, > which would require the ethernet driver to be loaded as a module, too. > Which isn't the case for most devices (I think the x86 target is the > only exception for that). > > If it has changed since then, I'm gladly corrected of course :) > > Regards > Jonas > _______________________________________________ > openwrt-devel mailing list > [email protected] > https://lists.openwrt.org/mailman/listinfo/openwrt-devel > _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
