so... what others think? it doesn't worth doing like this?
Regards, Roman On 29 September 2010 15:45, Roman Yeryomin <[email protected]> wrote: > I've tested this with ramips board. > Of cause device should be registered but it's intended to be selected > automatically via target board profiling. For now it should be > selected manually. > Without this you'll have to say RTL8366RB/S_PHY=y in target kernel > config which will be applied to all boards what is useless because not > all boards have these switches. > > Regards, > Roman > > On 29 September 2010 15:04, Jonas Gorski <[email protected]> > wrote: >> Hi >> >> On 29 September 2010 13:22, Roman Yeryomin <[email protected]> wrote: >>> Add rtl8366 switch kernel packages so that they could be selected if a >>> user has board with such switch. >> >> I do not think this will work for most targets. The last time I tried, >> phy devices are only probed on ethernet device driver registration, >> which would require the ethernet driver to be loaded as a module, too. >> Which isn't the case for most devices (I think the x86 target is the >> only exception for that). >> >> If it has changed since then, I'm gladly corrected of course :) >> >> Regards >> Jonas >> _______________________________________________ >> openwrt-devel mailing list >> [email protected] >> https://lists.openwrt.org/mailman/listinfo/openwrt-devel >> > _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
