Al 27/02/11 12:11, En/na Maarten Bezemer ha escrit: > On Sat, 2011-02-26 at 20:20 +0100, Luca Olivetti wrote: >> I'm still trying to make openwrt work on my router (now a lantiq target, >> previously ifxmips) and I just noticed that the switch (an ar8216) doesn't >> pass data between ports, i.e (warning, lousy ASCII art follows): >> >> +--------------------+ >> | Router with ar8216 | >> +----+---+-----------+ >> | | >> | | >> +----+ | | +----+ >> | A +----+ +---+ B | >> +----+ +----+ >> >> The router can communicate with A and with B, but A and B cannot see >> each other. >> Note that they can see each other while in uboot, but as soon as the openwrt >> kernel takes over, they stop communicating. >> I'm currently using svn revision 25626 (around a week ago, but the ar8216 >> driver >> hasn't changed since november), linux 2.6.35.11. >> The kernel is configured with >> >> CONFIG_ADM6996_PHY=y >> CONFIG_AR8216_PHY=y >> CONFIG_RTL8306_PHY=y >> >> and I see from the boot messages that it finds the ar8216. >> >> Any hint? > > Are you using Backfire or trunk?
Trunk (svn revision 25626) > I think I had a similar problem (see my message of 06 Feb 2011), using > backfire r25399 on a WRT350nv2. From the router I could find both a pc > and the Internet modem. But from the PC it refused to find the modem (in > order to be able to Internet). > So it is not between tow LAN ports, but between a LAN and the WAN port, > but the problem is the same. I'm not sure it's the same but thanks anyway. Bye -- Luca _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
