On 02/02/2012 4:52:09 PM, Hauke Mehrtens wrote:
> On 01/28/2012 06:55 AM, Aaron Z wrote:
> > When I run "killall -9 hostapd" then "wifi" I get told:
> > "Configuration file: /var/run/hostapd-phy0.conf" and "Using
> > interface wlan0 with hwaddr MACADDRESS and ssid 'OpenWrt'"wifi is
> > still rejecting connections.
> > When I run "killall -9 hostapd; /usr/sbin/hostapd -dd
> > /var/run/hostapd-phy0.conf > /tmp/hostapd.log" it works right
> > away.
> This behavior is strange it could be that debugging activates some
> needed code path, hostapd just works after the second start or that
> there are timing issues. Could you run hostapd just with -d and
> without
> -d and report what happens in these cases?
Sorry for the delay. Its been busy around here.
I ran "killall -9 hostapd; /usr/sbin/hostapd -d /var/run/hostapd-phy0.conf >
/tmp/hostapd.log" I was able to connect and go online. The log is attached as
hostapd -d.txt (4 KB).
I then rebooted the WAP and ran "killall -9 hostapd; /usr/sbin/hostapd
/var/run/hostapd-phy0.conf > /tmp/hostapd.log" I was able to connect and go
online. The logfile was blank, so I didn't attach it.
I tried connecting before running the commands and was rejected both times.
Thanks
Aaron Z
random: Trying to read entropy from /dev/random
Configuration file: /var/run/hostapd-phy0.conf
nl80211: interface wlan0 in phy phy0
nl80211: Set mode ifindex 6 iftype 2 (STATION)
nl80211: Failed to set interface 6 to mode 2: -16 (Device or resource busy)
nl80211: Interface already in requested mode - ignore error
netlink: Operstate: linkmode=1, operstate=5
nl80211: Using driver-based off-channel TX
nl80211: Interface wlan0 is in bridge br-lan
nl80211: Add own interface ifindex 5
nl80211: Add own interface ifindex 6
nl80211: Set mode ifindex 6 iftype 3 (AP)
nl80211: Create interface iftype 6 (MONITOR)
Failed to create interface mon.wlan0: -23 (Too many open files in system)
Try to remove and re-create mon.wlan0
nl80211: Remove interface ifindex=7
nl80211: Create interface iftype 6 (MONITOR)
nl80211: New interface mon.wlan0 created: ifindex=8
nl80211: Add own interface ifindex 8
BSS count 1, BSSID mask 00:00:00:00:00:00 (0 bits)
nl80211: Regulatory information - country=00
nl80211: 2402-2472 @ 40 MHz
nl80211: 2457-2482 @ 20 MHz
nl80211: 2474-2494 @ 20 MHz
nl80211: 5170-5250 @ 40 MHz
nl80211: 5735-5835 @ 40 MHz
nl80211: Added 802.11b mode based on 802.11g information
Completing interface initialization
Mode: IEEE 802.11g Channel: 11 Frequency: 2462 MHz
nl80211: Set freq 2462 (ht_enabled=0 sec_channel_offset=0)
RATE[0] rate=10 flags=0x1
RATE[1] rate=20 flags=0x1
RATE[2] rate=55 flags=0x1
RATE[3] rate=110 flags=0x1
RATE[4] rate=60 flags=0x0
RATE[5] rate=90 flags=0x0
RATE[6] rate=120 flags=0x0
RATE[7] rate=180 flags=0x0
RATE[8] rate=240 flags=0x0
RATE[9] rate=360 flags=0x0
RATE[10] rate=480 flags=0x0
RATE[11] rate=540 flags=0x0
Flushing old station entries
Deauthenticate all stations
wpa_driver_nl80211_set_key: ifindex=6 alg=0 addr=(nil) key_idx=0 set_tx=0
seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=6 alg=0 addr=(nil) key_idx=1 set_tx=0
seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=6 alg=0 addr=(nil) key_idx=2 set_tx=0
seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=6 alg=0 addr=(nil) key_idx=3 set_tx=0
seq_len=0 key_len=0
Using interface wlan0 with hwaddr 00:88:88:88:00:2a and ssid 'OpenWrt'
Using existing control interface directory.
ctrl_iface bind(PF_UNIX) failed: Address already in use
ctrl_iface exists, but does not allow connections - assuming it was leftover
from forced program termination
Successfully replaced leftover ctrl_iface socket '/var/run/hostapd-phy0/wlan0'
nl80211: Set beacon (beacon_set=0)
wpa_driver_nl80211_set_operstate: operstate 0->1 (UP)
netlink: Operstate: linkmode=-1, operstate=6
wlan0: Setup of interface done.
RTM_NEWLINK: operstate=1 ifi_flags=0x11003 ([UP][LOWER_UP])
netlink: Operstate: linkmode=-1, operstate=6
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
Unknown event 5
nl80211: Add ifindex 5 for bridge br-lan
nl80211: Add own interface ifindex 5
RTM_NEWLINK: operstate=1 ifi_flags=0x11003 ([UP][LOWER_UP])
netlink: Operstate: linkmode=-1, operstate=6
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
Unknown event 5
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface wlan0 is up
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface wlan0 is up
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface wlan0 is up
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface wlan0 is up
nl80211: Ignore event for foreign ifindex 7
nl80211: Ignore dellink event for foreign ifindex 7
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface mon.wlan0 is up
RTM_NEWLINK: operstate=1 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'mon.wlan0' added
Unknown event 5
mgmt::deauth cb
RTM_NEWLINK: operstate=1 ifi_flags=0x11003 ([UP][LOWER_UP])
netlink: Operstate: linkmode=-1, operstate=6
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
Unknown event 5
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
