Hi!
I just tried the 3.6.6 kernel with the trunk from yesterday. I get the
following kernel panic:
------------------------------------------------------------------------------------
XR9-x chip found
DDR set @ 166.6MHz
Check initial DDR setting...DDR check ok... start booting...
ARCADYAN U-Boot 1.00 (Nov 10 2010 - 17:41:42)
AR9 BOARD
CLOCK CPU 333M RAM 166M
DRAM: 64 MB
relocate_code start
relocate_code finish.
Flash: 32 MB
In: serial
Out: serial
Err: serial
Net:
switch chip id=00001001
AR8316
amazon_s Switch
Copying boot params.....
DONE
Type "run flash_nfs" to mount root filesystem over NFS
Hit any key to stop autoboot: 0
## Booting image at b0060000 ...
Image Name: MIPS OpenWrt Linux-3.6.6
Created: 2012-11-08 20:37:24 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1049745 Bytes = 1 MB
Load Address: 80002000
Entry Point: 80002000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80002000) ...
## Giving linux memsize in MB, 64
Starting kernel ...
[ 0.000000] Linux version 3.6.6 (avalentin@varus) (gcc version 4.6.4
20121001 (prerelease) (Linaro GCC 4.6-2012.10) ) #6 Thu Nov 8 21:37:22 CET 2012
[ 0.000000] SoC: AR9 rev 1.2
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 0001954c (MIPS 34Kc)
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 04000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x03ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x03ffffff]
[ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32
bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total
pages: 16256
[ 0.000000] Kernel command line: console=ttyLTQ0,115200 init=/etc/preinit
[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] __ex_table already sorted, skipping sort
[ 0.000000] Writing ErrCtl register=000692a5
[ 0.000000] Readback ErrCtl register=000692a5
[ 0.000000] Memory: 61628k/65536k available (2455k kernel code, 3908k
reserved, 428k data, 176k init, 0k highmem)
[ 0.000000] NR_IRQS:256
[ 0.000000] CPU Clock: 600MHz
[ 0.000000] Calibrating delay loop... 397.82 BogoMIPS (lpj=795648)
[ 0.032000] pid_max: default: 32768 minimum: 301
[ 0.032000] Mount-cache hash table entries: 512
[ 0.036000] pinctrl core: initialized pinctrl subsystem
[ 0.040000] NET: Registered protocol family 16
[ 0.044000] dma-xway 1e104100.dma: Init done - hw rev: 6, ports: 5,
channels: 20
[ 0.048000] dma-xway 1e104100.dma: init done
[ 0.052000] pinctrl-xway 1e100b10.pinmux: Init done
[ 0.056000] gptu-xway 1e100a00.gptu: gptu: 6 timers loaded
[ 0.060000] Data bus error, epc == 80262008, ra == 80261fcc
[ 0.060000] Oops[#1]:
[ 0.060000] Cpu 0
[ 0.060000] $ 0 : 00000000 00000067 be105400 feffffff
[ 0.060000] $ 4 : ffffffff 80295a20 83829ce4 00000007
[ 0.060000] $ 8 : 00000020 00000003 00000008 ffffff80
[ 0.060000] $12 : 03bd0000 ac000000 00000000 64000000
[ 0.060000] $16 : 83857788 80330000 83857780 80330000
[ 0.060000] $20 : 81000c0c 80330000 80330000 80330000
[ 0.060000] $24 : 00000018 8000364c
[ 0.060000] $28 : 83828000 83829d60 802b321c 80261fcc
[ 0.060000] Hi : 00000000
[ 0.060000] Lo : 00000000
[ 0.060000] epc : 80262008 0x80262008
[ 0.060000] Not tainted
[ 0.060000] ra : 80261fcc 0x80261fcc
[ 0.060000] Status: 1100fc03 KERNEL EXL IE
[ 0.060000] Cause : 1080001c
[ 0.060000] PrId : 0001954c (MIPS 34Kc)
[ 0.060000] Modules linked in:
[ 0.060000] Process swapper (pid: 1, threadinfo=83828000, task=83827928,
tls=00000000)
[ 0.060000] Stack : 83857790 ffffffed 802bc680 802ce634 00000016 83857788
80330000 802ce634
ffffffed 802bc680 802ce634 00000016 802d3210 8016e730 83857788 802ce634
802ce634 8017009c 834015e0 838577bc 83857788 802ce634 802ce634 00000000
80300000 8016e908 802ce634 8016ca1c 8385d480 00000000 00000000 802ce634
8016e89c 8016cd18 00000000 83860288 802cc0a0 8016c99c 838254cc 8385db30
...
[ 0.060000] Call Trace:[<802d3210>] 0x802d3210
[ 0.060000] [<8016e730>] 0x8016e730
[ 0.060000] [<8017009c>] 0x8017009c
[ 0.060000] [<8016e908>] 0x8016e908
[ 0.060000] [<8016ca1c>] 0x8016ca1c
[ 0.060000] [<8016e89c>] 0x8016e89c
[ 0.060000] [<8016cd18>] 0x8016cd18
[ 0.060000] [<8016c99c>] 0x8016c99c
[ 0.060000] [<8016dcc0>] 0x8016dcc0
[ 0.060000] [<80106ba0>] 0x80106ba0
[ 0.060000] [<802e5314>] 0x802e5314
[ 0.060000] [<8016ecb0>] 0x8016ecb0
[ 0.060000] [<802d3210>] 0x802d3210
[ 0.060000] [<80106cf8>] 0x80106cf8
[ 0.060000] [<802e5314>] 0x802e5314
[ 0.060000] [<802e532c>] 0x802e532c
[ 0.060000] [<80002900>] 0x80002900
[ 0.060000] [<802d3a44>] 0x802d3a44
[ 0.060000] [<802d3210>] 0x802d3210
[ 0.060000] [<800064a0>] 0x800064a0
[ 0.060000] [<802d3908>] 0x802d3908
[ 0.060000] [<80006490>] 0x80006490
[ 0.060000]
[ 0.060000]
Code: 8c440030 3c03feff 3463ffff <00831824> ac430030 0000000f 8e63f6a0
8e22f6a4 3c058029
[ 0.064000] ---[ end trace 139ce121c98e96c9 ]---
[ 0.064000] Kernel panic - not syncing: Attempted to kill init!
exitcode=0x0000000b
[ 0.064000]
------------------------------------------------------------------------------------
Does somebody have an idea what I did wrong? It's no problem for me to test, I
have serial console ;-)
André
Mit freundlichen Grüßen,
André Valentin
Systemadministrator
--
Internet * Netzwerk * Mobile Daten
Citrix Silver Solution Advisor
MarcanT GmbH, Ravensberger Str. 10 G, D - 33602 Bielefeld
Fon: +49 (521) 95945-0 | Fax -18
URL: http://www.marcant.net | http://www.global-m2m.com
Geschäftsführer: Thorsten Hojas
Handelsregister: AG Bielefeld, HRB 35827 USt-ID Nr.: DE 190203238
___________________________________________________________
CONFIDENTIALITY NOTICE
The contents of this email are confidential to the ordinary user of the email
address to which it was addressed and may also be privileged. If you are not
the addressee of this email you may not copy, forward, disclose or otherwise
use it or any part of it in any form whatsoever. If you have received this
email in error please email the sender by replying to this message.
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
