[OpenWrt-Devel] [PATCH] lantiq: remove read-only flag on two partitions on BTHOMEHUBV3A

Sun, 24 Apr 2016 12:30:06 -0700 

Remove read-only flag on two partitions on BTHOMEHUBV3A:
  uboot-config - otherwise fw_setenv command cannot be used.
  ath9k-cal    - so that ath9k calibration data can be copied
                 to the partition on a newly installed board.
 
Signed-off-by: Ben Mulvihill <[email protected]>
---
--- a/target/linux/lantiq/dts/BTHOMEHUBV3A.dts  2016-04-24 17:30:44.117072962 
+0200
+++ b/target/linux/lantiq/dts/BTHOMEHUBV3A.dts  2016-04-24 17:30:08.483732762 
+0200
@@ -61,12 +61,10 @@
                                partition@64000 {
                                        label = "uboot-config";
                                        reg = <0x64000 0x004000>;
-                                       read-only;
                                };
                                ath9k_cal: partition@68000 {
                                        label = "art-copy";
                                        reg = <0x68000 0x004000>;
-                                       read-only;
                                };
                                partition@6c000 {
                                        label = "kernel";
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel

Reply via email to