On 24/04/2016 21:29, Ben Mulvihill wrote:
> Remove read-only flag on two partitions on BTHOMEHUBV3A:
> uboot-config - otherwise fw_setenv command cannot be used.
> ath9k-cal - so that ath9k calibration data can be copied
> to the partition on a newly installed board.
>
> Signed-off-by: Ben Mulvihill <[email protected]>
> ---
> --- a/target/linux/lantiq/dts/BTHOMEHUBV3A.dts 2016-04-24
> 17:30:44.117072962 +0200
> +++ b/target/linux/lantiq/dts/BTHOMEHUBV3A.dts 2016-04-24
> 17:30:08.483732762 +0200
> @@ -61,12 +61,10 @@
> partition@64000 {
> label = "uboot-config";
> reg = <0x64000 0x004000>;
> - read-only;
> };
> ath9k_cal: partition@68000 {
> label = "art-copy";
> reg = <0x68000 0x004000>;
> - read-only;
> };
is this not a bit risky ? normally we try to keep them read-only so that
users cannot accidentally kill them. is the calib data normally not
located in the art partition or why do you need to copy it after flashing ?
> partition@6c000 {
> label = "kernel";
> _______________________________________________
> openwrt-devel mailing list
> [email protected]
> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
>
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
