On 2018-05-25 13:30, Zoltan Gyarmati wrote:
Dear All,
I'm testing the current OpenWrt (master/HEAD) on RT5350F Olinuxino.
Unfortunately the WiFi interface doesn't seem to work properly in
client mode. `iwinfo wlan0 scan` runs successfully and shows my AP,
but when i configure the interface as client and try to connect, the
authentication seems to be successful (according to dmesg), but the
wlan0 interface never gets IP address, even if i explicitly call
udhcpc. If i set a static IP address for wlan0, and ping my AP, i have
around 88% packet loss. There is no any relevant message in dmesg
which could give a hint about the reason.
As a counter-check, i flashed the an old OpenWrt image from the HW
vendor with kernel 3.18, and with that one the WiFi interface works
properly.
Does anyone else experience similar issues (either on this or any
other RT5350F board)? Do you have any advice what to look into to sort
this out?
Thanks,
Hi,
When you build master, did it already contain commit "hostapd: update to
git HEAD of 2018-05-21, allow build against wolfssl" ?
Could you also try to build the 18.06 which does not contain this one
and compare?
You never know..
Koen
[1]
https://git.openwrt.org/?p=openwrt/openwrt.git;a=commit;h=69f544937f8498e856690f9809a016f0d7f5f68b
_______________________________________________
openwrt-devel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/openwrt-devel
