The sender domain has a DMARC Reject/Quarantine policy which disallows
sending mailing list messages using the original "From" header.

To mitigate this problem, the original message has been wrapped
automatically by the mailing list software.
--- Begin Message ---
This patch adds supports for GL-AR750S.
Right now this patch adds nor image generation only.
NAND image generation is not supportet at the moment.
Furtheremore the MicroSD port is not implemented as of now.

Specification:
- SOC: QCA9563 (775MHz)
- Flash: 16 MiB (W25Q128FVSG)
- RAM: 128 MiB DDR2
- Ethernet: 2x 1Gbps LAN + 1x 1Gbps WAN
- Wireless: 2.4GHz (bgn) and 5GHz (ac)
- USB: 1x USB 2.0 port
- Button: 1x switch button, 1x reset button
- LED: 3x LEDS (green)
  - Another LED can be accessed on GPIO 7 if soldered

Flash instruction:
- Set static ip to 192.168.1.2
- Unplug the power cord
- Hold reset button
- Plug power back in
- Right led will flash 5 times
- Release reset button
- Browse to 192.168.1.1
- Choose sysupgrade image in NOR-flash section
- Press "update nor firmware"
- After successful transfer unplug network cable before device restarts

Signed-off-by: Christoph Krapp <[email protected]>
---
 .../ath79/base-files/etc/board.d/02_network   |   4 +
 .../etc/hotplug.d/firmware/11-ath10k-caldata  |   9 +-
 .../linux/ath79/dts/qca9563_glinet_ar750s.dts | 153 ++++++++++++++++++
 target/linux/ath79/image/generic.mk           |   9 ++
 4 files changed, 171 insertions(+), 4 deletions(-)
 create mode 100644 target/linux/ath79/dts/qca9563_glinet_ar750s.dts

diff --git a/target/linux/ath79/base-files/etc/board.d/02_network 
b/target/linux/ath79/base-files/etc/board.d/02_network
index 004ab59573..b9a0f356bf 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -93,6 +93,10 @@ ath79_setup_interfaces()
        glinet,gl-x750)
                ucidef_set_interfaces_lan_wan "eth1" "eth0"
                ;;
+       glinet,ar750s)
+               ucidef_add_switch "switch0" \
+                       "0@eth0" "2:lan:2" "3:lan:1" "1:wan"
+               ;;
        nec,wg800hp)
                ucidef_add_switch "switch0" \
                        "0@eth0" "2:lan" "3:lan" "4:lan" "1:wan"
diff --git 
a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata 
b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 53f57be824..2118d2b06b 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -92,6 +92,11 @@ case "$FIRMWARE" in
                ath10kcal_extract "art" 20480 2116
                ath10kcal_patch_mac_crc $(macaddr_add $(mtd_get_mac_binary art 
0) -1)
                ;;
+       glinet,ar750s|\
+       tplink,re450-v2)
+               ath10kcal_extract "art" 20480 2116
+               ath10kcal_patch_mac $(macaddr_add $(cat 
/sys/class/net/eth0/address) +1)
+               ;;
        glinet,gl-x750)
                ath10kcal_extract "art" 20480 2116
                ath10kcal_patch_mac $(macaddr_add $(cat 
/sys/class/net/eth0/address) +1)
@@ -122,10 +127,6 @@ case "$FIRMWARE" in
                ath10kcal_extract "art" 20480 2116
                ath10kcal_patch_mac $(macaddr_add $(cat 
/sys/class/net/eth0/address) -1)
                ;;
-       tplink,re450-v2)
-               ath10kcal_extract "art" 20480 2116
-               ath10kcal_patch_mac $(macaddr_add $(cat 
/sys/class/net/eth0/address) +1)
-               ;;
        ubnt,unifiac-lite|\
        ubnt,unifiac-mesh|\
        ubnt,unifiac-mesh-pro|\
diff --git a/target/linux/ath79/dts/qca9563_glinet_ar750s.dts 
b/target/linux/ath79/dts/qca9563_glinet_ar750s.dts
new file mode 100644
index 0000000000..b46a75c4af
--- /dev/null
+++ b/target/linux/ath79/dts/qca9563_glinet_ar750s.dts
@@ -0,0 +1,153 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca956x.dtsi"
+
+/ {
+       compatible = "glinet,ar750s", "qca,qca9563";
+       model = "GL.iNet GL-AR750S";
+
+       chosen {
+               bootargs = "console=ttyS0,115200n8";
+       };
+
+       aliases {
+               led-boot = &power;
+               led-failsafe = &power;
+               led-running = &power;
+               led-upgrade = &power;
+       };
+
+       keys {
+               compatible = "gpio-keys-polled";
+               poll-interval = <20>;
+               pinctrl-names = "default";
+               pinctrl-0 = <&jtag_disable_pins>;
+
+               button0 {
+                       label = "reset";
+                       linux,code = <KEY_RESTART>;
+                       gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
+               };
+
+               button1 {
+                       label = "button right";
+                       linux,code = <BTN_0>;
+                       gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
+               };
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               power: power {
+                       label = "gl-ar750s:green:power";
+                       gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
+                       default-state = "keep";
+               };
+
+               wlan2g {
+                       label = "gl-ar750s:green:wlan2g";
+                       gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
+                       linux,default-trigger = "phy1tpt";
+               };
+
+               wlan5g {
+                       label = "gl-ar750s:green:wlan5g";
+                       gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
+                       linux,default-trigger = "phy0tpt";
+               };
+       };
+};
+
+&spi {
+       status = "okay";
+       num-cs = <0>;
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <25000000>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       partition@0 {
+                               label = "u-boot";
+                               reg = <0x000000 0x040000>;
+                               read-only;
+                       };
+
+                       partition@40000 {
+                               label = "u-boot-env";
+                               reg = <0x040000 0x010000>;
+                       };
+
+                       art: partition@50000 {
+                               label = "art";
+                               reg = <0x050000 0x010000>;
+                       };
+
+                       partition@60000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x060000 0xfa0000>;
+                       };
+               };
+       };
+};
+
+&pcie {
+       status = "okay";
+};
+
+&uart {
+       status = "okay";
+};
+
+&usb0 {
+       #address-cells = <1>;
+       #size-cells = <0>;
+       status = "okay";
+
+       hub_port: port@1 {
+               reg = <1>;
+               #trigger-source-cells = <0>;
+       };
+};
+
+&usb_phy0 {
+       status = "okay";
+};
+
+&mdio0 {
+       status = "okay";
+       phy-mask = <0>;
+
+       phy0: ethernet-phy@0 {
+               reg = <0>;
+               phy-mode = "sgmii";
+               qca,ar8327-initvals = <
+                       0x04 0x00080080 /* PORT0 PAD MODE CTRL */
+                       0x7c 0x0000007e /* PORT0_STATUS */
+               >;
+       };
+};
+
+&eth0 {
+       status = "okay";
+
+       mtd-mac-address = <&art 0x0>;
+       phy-handle = <&phy0>;
+};
+
+&wmac {
+       status = "okay";
+       mtd-cal-data = <&art 0x1000>;
+       mtd-mac-address = <&art 0x1002>;
+};
diff --git a/target/linux/ath79/image/generic.mk 
b/target/linux/ath79/image/generic.mk
index b2f83ba58c..c61148d50e 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -237,6 +237,15 @@ define Device/glinet_ar300m-nor
 endef
 TARGET_DEVICES += glinet_ar300m-nor
 
+define Device/glinet_ar750s
+  ATH_SOC := qca9563
+  DEVICE_TITLE := GL.iNet GL-AR750S
+  DEVICE_PACKAGES := kmod-usb2 kmod-ath10k-ct ath10k-firmware-qca988x-ct
+  IMAGE_SIZE := 16000k
+  SUPPORTED_DEVICES += gl-ar750s
+endef
+TARGET_DEVICES += glinet_ar750s
+
 define Device/glinet_gl-x750
   ATH_SOC := qca9531
   DEVICE_TITLE := GL.iNet GL-X750
-- 
2.19.2



--- End Message ---
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel

Reply via email to