Hi Christian, On Sat, 2022-06-18 at 02:24 +0200, Christian Lamparter wrote: > Hi, > > On 18/06/2022 01:26, Sebastian Schaper wrote: > > unfortunately, testing these changes on DAP-2680 resulted in board-2.bin > > not being loaded, the driver is only looking for board.bin instead. > > > > [ 12.476846] ath10k 5.15 driver, optimized for CT firmware, probing pci > > device: 0x46. > > [ 12.486197] ath10k_pci 0000:00:00.0: enabling device (0000 -> 0002) > > [ 12.492883] ath10k_pci 0000:00:00.0: pci irq legacy oper_irq_mode 1 > > irq_mode 0 reset_mode 0 > > [ 15.751865] ath10k_pci 0000:00:00.0: qca9984/qca9994 hw1.0 target > > 0x01000000 chip_id > > 0x00000000 sub 168c:cafe > > [ 15.761962] ath10k_pci 0000:00:00.0: kconfig debug 0 debugfs 1 tracing 0 > > dfs 1 testmode 0 > > [ 15.781211] ath10k_pci 0000:00:00.0: firmware ver > > 10.4b-ct-9984-fW-13-5ae337bb1 api 5 > > features > > mfp,peer-flow-ctrl,txstatus-noack,wmi-10.x-CT,ratemask-CT,regdump-CT,txrate-CT,flush- > > all-CT,pingpong-CT,ch-regs-CT,nop-CT,set-special-CT,tx-rc-CT,cust-stats-CT,txrate2-CT,beacon-cb- > > CT,wmi-block-ack-CT,wmi-bcn-rc-CT crc32 7ea63dc5 > > [ 18.114113] ath10k_pci 0000:00:00.0: Loading BDF type 0 > > [ 18.123845] ath10k_pci 0000:00:00.0: failed to fetch board data for > > bus=pci,vendor=168c,device=0046,subsystem-vendor=168c,subsystem-device=cafe > > from > > ath10k/QCA9984/hw1.0/board-2.bin > > [ 18.737015] ath10k_pci 0000:00:00.0: failed to fetch board-2.bin or > > board.bin from > > ath10k/QCA9984/hw1.0 > > [ 18.746595] ath10k_pci 0000:00:00.0: failed to fetch board file: -12 > > [ 18.767513] ath10k_pci 0000:00:00.0: could not probe fw (-12) > > Technically, the Wave-2 chips like the 9984 need the "pre-calibration" > as the nvmem-cell-names string over "calibration". If you change it, > it will pick up the matching entry in board-2.bin...
Thanks, I wasn't aware of this. I'll update the patches and send a v3. Best, Sander _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
