#13432: Phicomm M1 (new platform)
---------------------------+----------------------------------
  Reporter:  mbielowicz@…  |      Owner:  hauke
      Type:  task          |     Status:  closed
  Priority:  high          |  Milestone:  Chaos Calmer (trunk)
 Component:  base system   |    Version:  Trunk
Resolution:  fixed         |   Keywords:
---------------------------+----------------------------------

Comment (by anonymous):

 Hi,

 2 weaks ago, I also flashed openwrt-brcm47xx-generic-squashfs.trx.

 I have no ping or something else over lan. On serial console I get the
 following output:


 {{{
 Decompressing...done


 CFE version 5.100.138.9 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
 Build Date: Wed Dec 21 13:25:44 CST 2011 (zhaoyanming@wireless)
 Copyright (C) 2000-2008 Broadcom Corporation.

 Init Arena
 Init Devs.
 Boot partition size = 131072(0x20000)
 Found an ST compatible serial flash with 64 64KB blocks; total size 4MB
 et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.9
 CPU type 0x19749: 300MHz
 Tot mem: 32768 KBytes

 CFE mem:    0x80700000 - 0x807990C0 (626880)
 Data:       0x8072EF10 - 0x80732130 (12832)
 BSS:        0x80732130 - 0x807330C0 (3984)
 Heap:       0x807330C0 - 0x807970C0 (409600)
 Stack:      0x807970C0 - 0x807990C0 (8192)
 Text:       0x80700000 - 0x8072EF04 (192260)

 Device eth0:  hwaddr D8-42-AC-8B-9B-52, ipaddr 192.168.1.1, mask
 255.255.255.0
         gateway not set, nameserver not set
 Loader:raw Filesys:tftp Dev:eth0 File:: Options:(null)
 Loading: Failed.
 Could not load :: Timeout occured
 Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
 Loading: .. 3712 bytes read
 Entry at 0x80001000
 Closing network.
 Starting program at 0x80001000
 }}}

 It's nearly exat the same as in the first comment. Only the 4th last line
 is different: he reads only 7312 bytes and not 3780 bytes.

 But after this shown block, the output is stopping. What can I do to get a
 working lan port/image?
 I use minicom in terminal and only modify the configuration from serial
 port to
 == /dev/ttyS0 ==
 and
 == Hardware Flow Control :  No ==

 Have I done anything wrong, do I need some other configuration? What shall
 I do to rescue?

 Thanks for any help!

--
Ticket URL: <https://dev.openwrt.org/ticket/13432#comment:15>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets

Reply via email to