Hi,
Can you run the following command in your AP (Have DHCP sever)
#cat /etc/config/dhcp
I guess your dhcp configuration has something wrong
Thanks,
Nam.
On 24 October 2015 at 00:19, Nemesis <[email protected]> wrote:
> Hi everybody,
>
> I'm trying to understand how WDS works with 2 TP-Link WDR4300.
>
> Is this wiki page still relevant?
> http://wiki.openwrt.org/doc/recipes/atheroswds
>
> I have successfully connected the two routers via wifi, I see confirmation
> of this in the AP both via the luci interface and via ifconfig (because I
> see "wlan0.sta1").
>
> The problem is that the client doesn't et an IP address from the DHCP
> server running on the AP, so I cannot reach the internet nor any other host
> in the network.
>
> I also do not understand how to debug, what commands and tools should I
> use to understand what I'm doing wrong?
>
> the situation on the client router is as follows:
>
> - the arp table is empty;
> - the routing table is empty;
> - bridge is brought up correctly between eth0.1 and wlan0 (wds client)
> but no DHCP lease is obtained from the AP
>
> Any other link to read and study?
>
> Thanks
> Federico
>
> _______________________________________________
> openwrt-users mailing list
> [email protected]
> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
>
>
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
