> Sent: Saturday, October 24, 2015 at 2:29 PM
> From: "Morten Christensen" <[email protected]>
> To: [email protected]
> Subject: Re: [OpenWrt-Users] Installing OpenWrt on WRT54G v2.2
>
> Den 21-10-2015 kl. 22:49 skrev Genghis Khan:
> > So far I use my newly born router as a wireless adapter. It seems to
> > work well, except not being able to access to OpenWrt from the IP
> > address I set up for it (IP is 192.168.0.1, different than
> > 192.168.1.1), even though I was able to, earlier this session.
> >
>
> If I understand you correct:
>
> Your internet-router has an active dhcp-server, that gives your LAN
> adresses in the 192.168.1.x-subnet.
>
> Your OpenWRT/wrt54g-box has a fix'ed ip-address 192.168.0.1. A different
> subnet from your LAN. When you try to enter a not-local
> address on your PC, it sends the request to its default gateway - the
> internetrouter.
>
> Have you tried to give the ethernet-card of your computer a fix'ed
> ip-address of f.x. 192.168.0.234, subnet 255.255.255.0 and then connect
> to a LAN-port on the OpenWRT/wrt54g-box with cable.
>
> If I understand your setup correct, then you should be able to connect
> to the OpenWRT on 192.168.0.1 and change its ip-address to a not used
> address on your LAN 192.168.1.x.
>
Indeed so! Thank you, I have gained access to my free router again!
1. Open WICD
2. Click on Properties
3. Check: Use Static IPs
4. Enter these values:
IP: 192.168.0.234
Netmask: 255.255.255.0
Gateway: 192.168.0.1
5. Click: OK
6. Reconnect
I have added these to new ethernet profile in WICD called OpenWrt.
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
