I'm using the v3.7.0 virtual appliance. It's running on VMware ESX (vSphere 4.0).
I added my first host, a Cisco 6500 multilayer switch. I selected 3 host templates: Network-Base, Network-Cisco, and SNMP-Cisco. Monitoring took place, and I was given a warning about memory utilization, but there were no graphs. It was not until I went into the Host Configuration / Service Monitors and selected (checked) the 2 Network-Cisco services and did a Reload that the graphs in the Service Status page appeared. Having selected the Network-Cisco template I would not think that I would have to go into Services and select those Services individually. 1) Is this normal? 2) If so, what is the purpose of the templates? 3) What should I have done? In my previous work with Nagios it used a simple ping as a "host check" while any other check was a "service check." Did I mix these up here in Opsview? I don't see the distinction in this configuration interface. Thanks CONFIDENTIALITY NOTICE: This message contains information which may be confidential or privileged. If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited. If you have received this transmission in error, please notify me immediately by telephone.
_______________________________________________ Opsview-users mailing list Opsview-users@lists.opsview.org http://lists.opsview.org/lists/listinfo/opsview-users
