Make sure that the result of "hostname" is the -external- network
interface. This is not usually the interface used by the OSCAR installer.
Theres some other tips on two network interface setups here.
http://svn.oscar.openclustergroup.org/trac/oscar/wiki/TipTwoNetworkInterfaces
On Nov 19, 2007 11:20 AM, Lary, Jeffrey <[EMAIL PROTECTED]> wrote:
> Thank you for your reply. I was able, with the help given in the link, to
> PXE image and successfully boot the two nodes.
> Now on to the next problem. I ran Step 7 to complete the cluster setup
> and it failed on the Torque queue setup and multiple errors down through to
> the end with a failure in the MTA setup. I've attached a compressed
> oscarinstall.log. The pbs_server.log mainly shows the error.
>
> "11/19/2007 11:16:30;0080;PBS_Server;Req;req_reject;Reject reply
> code=15064(Server has no node list), aux=0, type=StatusNode, from
> [EMAIL PROTECTED]"
>
>
> Any help would be greatly appreciated.
>
> Thanks,
> Jeff Lary.
>
>
> -----Original Message-----
> From: [EMAIL PROTECTED] on behalf of Michael
> Edwards
> Sent: Sat 11/17/2007 12:03 PM
> To: oscar-users@lists.sourceforge.net
> Subject: Re: [Oscar-users] Kernel panic after node PXE install on Dell PE
> 860
>
> Dell likes to use funny drivers which don't always get detected properly
> by
> the scripts which SIS (and therefore OSCAR) use for detecting hardware.
> Look at the PE1955 bits of this howto and see if they help you.
>
> http://svn.oscar.openclustergroup.org/trac/oscar/wiki/TipLDAP
>
> Since you have identical hardware on the head and the compute nodes, I
> would
> use the modprobe.conf on the head node to base the node one on instead of
> the one for the PE1955.
>
> On Nov 17, 2007 11:08 AM, Lary, Jeffrey <[EMAIL PROTECTED]> wrote:
>
> > I have three identical PE 860s. I installed CentOS 4.5 x86_64 on one
> > (head node) without any problems. I installed Oscar 5.0 successfully
> and
> > proceeded all the way through Step 6. I PXE booted one of the other
> nodes
> > and the installation, via PXE, proceeded through to completion and the
> node
> > rebooted. At that point it went through the grub kernel selection
> screen
> > and continued on through the boot process. Soon the boot sequence
> stopped,
> > ending with a kernel panic. The last few lines are shown below -
> >
> > ...
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Oscar-users mailing list
> Oscar-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/oscar-users
>
>
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Oscar-users mailing list
Oscar-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/oscar-users
