Michael, hostname gives the correct result, i.e. that of the external interface.
Thanks, Jeff Lary -----Original Message----- From: [EMAIL PROTECTED] on behalf of Michael Edwards Sent: Mon 11/19/2007 11:52 AM To: oscar-users@lists.sourceforge.net Subject: Re: [Oscar-users] Kernel panic after node PXE install on Dell PE 860 Make sure that the result of "hostname" is the -external- network interface. This is not usually the interface used by the OSCAR installer. Theres some other tips on two network interface setups here. http://svn.oscar.openclustergroup.org/trac/oscar/wiki/TipTwoNetworkInterfaces On Nov 19, 2007 11:20 AM, Lary, Jeffrey <[EMAIL PROTECTED]> wrote: > Thank you for your reply. I was able, with the help given in the link, to > PXE image and successfully boot the two nodes. > Now on to the next problem. I ran Step 7 to complete the cluster setup > and it failed on the Torque queue setup and multiple errors down through to > the end with a failure in the MTA setup. I've attached a compressed > oscarinstall.log. The pbs_server.log mainly shows the error. > > "11/19/2007 11:16:30;0080;PBS_Server;Req;req_reject;Reject reply > code=15064(Server has no node list), aux=0, type=StatusNode, from > [EMAIL PROTECTED]" > > > Any help would be greatly appreciated. > > Thanks, > Jeff Lary. > > > -----Original Message----- > From: [EMAIL PROTECTED] on behalf of Michael > Edwards > Sent: Sat 11/17/2007 12:03 PM > To: oscar-users@lists.sourceforge.net > Subject: Re: [Oscar-users] Kernel panic after node PXE install on Dell PE > 860 > > Dell likes to use funny drivers which don't always get detected properly > by > the scripts which SIS (and therefore OSCAR) use for detecting hardware. > Look at the PE1955 bits of this howto and see if they help you. > > http://svn.oscar.openclustergroup.org/trac/oscar/wiki/TipLDAP > > Since you have identical hardware on the head and the compute nodes, I > would > use the modprobe.conf on the head node to base the node one on instead of > the one for the PE1955. > > On Nov 17, 2007 11:08 AM, Lary, Jeffrey <[EMAIL PROTECTED]> wrote: > > > I have three identical PE 860s. I installed CentOS 4.5 x86_64 on one > > (head node) without any problems. I installed Oscar 5.0 successfully > and > > proceeded all the way through Step 6. I PXE booted one of the other > nodes > > and the installation, via PXE, proceeded through to completion and the > node > > rebooted. At that point it went through the grub kernel selection > screen > > and continued on through the boot process. Soon the boot sequence > stopped, > > ending with a kernel panic. The last few lines are shown below - > > > > ... > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Oscar-users mailing list > Oscar-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/oscar-users > >
<<winmail.dat>>
------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________ Oscar-users mailing list Oscar-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/oscar-users
