Hi Alan, On Feb 17, 2011, at 6:50 AM, Alan Davey wrote:
> Folks > > I have read draft-ietf-ospf-auth-trailer-ospfv3-02 and have a few minor nits > as follows. > > - After an unplanned graceful restart, a router may send Grace-LSAs > in an LS Update packet before any Hello packets. Unless I am missing > something, the draft should include such LS Update packets in the list of > those that MUST have the AT-bit set. The options are not included in the LS Update packet. However, if the restarting router was using the authentication restart before the restart, it should use it afterwards and the helping neighbor adjacencies should reflect this fact. > - In Figure 1, for the packet on the left hand side, the IP Header > Length HL = PL + LL (not PL + AL). Right - this will be included in the 03 version. > - In section 4.1 Authentication Trailer, in the Auth type bullet, > the following wording be clearer; “At present, the only value defined is 1, > to denote ...”? Ok - I'll reword this in the 03 version as well. Thanks, Acee > > Regards > Alan Davey > > Software Engineer, Network Technologies Division > Metaswitch Networks > [email protected] > +44 (0) 20 8366 1177 > www.metaswitch.com > > > _______________________________________________ > OSPF mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/ospf
_______________________________________________ OSPF mailing list [email protected] https://www.ietf.org/mailman/listinfo/ospf
