Hi Dimitri,
I think building your own RPB file containing RPC coefs is enough for a
proper orthorectification. There are no additionnal parameters required.
For the record, OTB also support RPC coef embedded in geotiff.
Regards,
Julien
Le 13/01/2016 16:40, Dimitris a écrit :
Hello all OTB people,
I know that OTB does not support RapidEye image orthorectification as
per documentation, however I attempted to orthorectify a level 1B
RapidEye image by tweaking the RPC.xml file (attached here) and
structure it as if it was an .RPB file with 102 lines (similar to the
one input for DG images), something that OTB can read when running.
The result is satisfactory. Can someone comment on whether this is
logical or something is missing (e.g. the sensor model is not included
in the OTB installation de facto and hence some parameters will be
ignored or not set correctly?). When in the OTB documentation is
mentioned that only some sensors are supported, does this has to do
with reading the .RPC file only or it is more complicated than I suspect?
Best,
Dimitris
--
--
Check the OTB FAQ at
http://www.orfeo-toolbox.org/FAQ.html
You received this message because you are subscribed to the Google
Groups "otb-users" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/otb-users?hl=en
---
You received this message because you are subscribed to the Google
Groups "otb-users" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected]
<mailto:[email protected]>.
For more options, visit https://groups.google.com/d/optout.
--
Julien MICHEL
CNES - DCT/SI/AP - BPI 1219
18, avenue Edouard Belin
31401 Toulouse Cedex 09 - France
Tel: +33 561 282 894 - Fax: +33 561 283 109
--
--
Check the OTB FAQ at
http://www.orfeo-toolbox.org/FAQ.html
You received this message because you are subscribed to the Google
Groups "otb-users" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/otb-users?hl=en
---
You received this message because you are subscribed to the Google Groups "otb-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
