Sorry missed the release part -
Release action is added first in this function before any other action is
processed which is used in decap case in our solution.
'nl_msg_put_flower_acts'
if (flower->tunnel.tunnel) {
act_offset = nl_msg_start_nested(request, act_index++);
nl_msg_put_act_tunnel_key_release(request);
nl_msg_end_nested(request, act_offset);
}
The ENCAP action is added fine in order within ' case TC_ACT_ENCAP:'
Thanks
Namrata
-----Original Message-----
From: Limaye, Namrata
Sent: Tuesday, August 21, 2018 11:22 AM
To: 'Ben Pfaff' <[email protected]>
Cc: [email protected]; [email protected]; Saha, Gargi
<[email protected]>; Choi, James <[email protected]>
Subject: RE: [ovs-dev] RX Mirroing issue with Decap in vxlan case
Hi Ben,
This is the configuration -
ovs-vsctl -- --id=@p get port vxlan0 -- [email protected] get Port eth0.128 --
[email protected] get Port eth0.129 -- --id=@m create Mirror name=mirror1
[email protected],@p [email protected] -- set Bridge br0 mirrors=@m
Thanks
Namrata
-----Original Message-----
From: Ben Pfaff [mailto:[email protected]]
Sent: Tuesday, August 21, 2018 11:15 AM
To: Limaye, Namrata <[email protected]>
Cc: [email protected]; [email protected]; Saha, Gargi
<[email protected]>; Choi, James <[email protected]>
Subject: Re: [ovs-dev] RX Mirroing issue with Decap in vxlan case
On Fri, Aug 17, 2018 at 06:55:39PM +0000, Limaye, Namrata wrote:
>
> Hi,
>
> I am facing an issue with Decap in RX Mirroring case (select_src_port)
> for Vxlan. With the following config –
>
> ovs-vsctl -- --id=@p get port vxlan0 -- [email protected]<mailto:[email protected]>
> get Port eth0.128 -- [email protected]<mailto:[email protected]> get Port eth0.129
> -- --id=@m create Mirror name=mirror1
> [email protected],@p<mailto:[email protected],@p>
> [email protected]<mailto:[email protected]> -- set Bridge br0
> mirrors=@m”.
>
> The order of action and ports is wrong. This is the order –
>
>
> 1. Release action
>
> 2. Mirror port (Non vxlan)
>
> 3. Output port (VXlan)
>
> For actions to be applied in the right order – the order should be –
>
> 1. Mirror port (non vxlan)
>
> 2. Release action
>
> 3. Output port (VXlan)
What's a release action?
Can you provide your configuration without corrupting it with <mailto:...>?
Thanks,
Ben.
_______________________________________________
dev mailing list
[email protected]
https://mail.openvswitch.org/mailman/listinfo/ovs-dev
