Hi everyone, It'd be appreciated if anyone could offer any suggestions regarding my problem below.
I have built up a DS2482-800 bus master, and everything is running fine with owfs, but only on bus 0. I have i2c-parport loaded, and owserver. I can see the device or devices I place on the chip IO0 line (with meaningful data being returned), but no devices is detected on any of the others. I've swapped end devices around, so I know it's not them. My logic probe tells me there is no attempt to drive the other bus lines low at all, so it would appear the filesystem is not scanning the other bus lines. Are there magic gems I'm missing here ? Many thanks - Greg ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Owfs-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/owfs-developers
