On 6/11/2015 11:16 AM, Lyle Giese wrote: > I have a 'new' Hobby-Board 4 port master hub. It appears to be a > working unit. I connected it via USB to a OpenSuSE box and using > minicom, I can talk to the unit and it responds. However I am unable to > get owfs to talk to it. > > The HB master hub is on /dev/ttyACM0 and I have used this command line > to try to get this running: > > owfs -d /dev/ttyACM0 --baud=9600 --6bit -m /mnt/1wire > > I think the above is the proper syntax to get owfs to talk to this > master hub. Or is it? > > Since minicom talks to the board just fine, I am thinking it's an owfs > command startup issue. When I issue the above, it just hangs and does > not return to the command prompt until I hit Ctrl-C. Nothing gets > registered in /mnt/1wire. But if I use a DS9490R (USB to 1wire adaptor) > with one of HB's older hubs, it works fine. But then it takes a > different command line syntax for that setup. > > Or is it an access issue accessing ttyACM0? Although minicom has no > problem with it. > > Any pointers? > > Lyle > > ------------------------------------------------------------------------------ > _______________________________________________ > Owfs-developers mailing list > Owfs-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/owfs-developers Not answering my question, but just adding some more info.
After leaving owfs in it's limbo state for about 20 or 30 minutes, it aborts leaving a message that it can not detect DS9097 (passive) on /dev/ttyACM0 and then 'No valid 1-wire buses found. Lyle ------------------------------------------------------------------------------ _______________________________________________ Owfs-developers mailing list Owfs-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/owfs-developers
