Hey,

I am trying to set up a simple Packetfence VLAN enforcement configuration. I’ve 
followed the Out-of-band quick guide on the website and I have ended up with an 
issue.
Whenever I connect to my Cisco 3750G switch it puts me in the Registration 
VLAN(10.1.2.x) even though I registered the first time and in the interface the 
device is set to registered.
However, what I expected is the retrieval of an IP address in the ‘default’ 
range (VLAN 400 as I set it up with the range 10.1.4.x)
Here is what I did, I configured in Packetfence VLAN 400 as the default and I 
added the following configuration to my Cisco 3750G switch.
The following is not everything I have configured, I have left out the other 
VLAN configuration.

ip dhcp pool default-pool
   network 10.1.4.0 255.255.255.0
   default-router 10.1.4.1
   dns-server 10.1.4.1

interface GigabitEthernet3/0/1
 switchport mode access vlan 200

interface GigabitEthernet3/0/2
 description uplink
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 1,200,300,400
 switchport mode trunk

interface Vlan400
 description default
 ip address 10.1.4.1 255.255.255.0

Could someone please help me with this issue.

Thanks a lot for your attention.

Best Regards,

Jeroen van Leur
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users

Reply via email to