Pretty sure it uses SNMP to perform a shut/no shut on the interface so make
sure that is set up correctly.
I think it can also use SSH access with credentials and the enable password if
you define it.
Be careful though as those credentials are stored in clear text in the
switches.conf file.
Andrew
From: Ondřej Lauer [mailto:[email protected]]
Sent: 06 April 2017 14:38
To: [email protected]
Subject: Re: [PacketFence-users] How to configure switch for VLAN changes ?
Hello Andrew,
thanks for your info. But I have already issued all but the last two. But
RADIUS works well both on switch and server. I am just not sure how the RADIUS
server tells the switch to change the VLANs and I am not sure whether I have
configured the switch for this properly.
Thank you very much
Ondrej
---------- Původní e-mail ----------
Od: Torry, Andrew <[email protected]>
Komu: [email protected]
<[email protected]>
Datum: 6. 4. 2017 11:47:11
Předmět: Re: [PacketFence-users] How to configure switch for VLAN changes ?
Hi Ondřej Lauer,
I assume you have the RADIUS stuff already set up on the switch so all you
should need is
aaa server radius dynamic-author
client <ManagementIP of your PF server>
server-key 0 <Your RADIUS key>
port 3799
If you want RADIUS accounting etc then it won’t hurt to throw in-
radius-server vsa send accounting
radius-server vsa send authentication
That should do it.
Andrew
Andrew Torry
Senior Infrastructure Engineer
Tel: 01326 370760
Email: [email protected]<mailto:[email protected]>
[cid:[email protected]]
[Falmouth Exeter Plus]
[cid:[email protected]]
[Twitter]<https://twitter.com/falmouthexeter>
[Facebook]<https://www.facebook.com/falmouthexeter>
[Instagram]<https://www.instagram.com/falmouthexeterplus/>
[YouTube]<https://www.youtube.com/channel/UC5-Jq4vTOhWgYoJJDYrZHWw>
[cid:[email protected]]
[Falmouth University]
Falmouth Exeter Plus is an exempt charity established by Falmouth University
and the University of Exeter to deliver their shared Higher Education services
in Cornwall.
From: Ondřej Lauer [mailto:[email protected]]
Sent: 05 April 2017 21:33
To: [email protected]
Subject: [PacketFence-users] How to configure switch for VLAN changes ?
Hello,
I am setting up PacketFence with VLAN control on Cisco 3750 switch. The RADIUS
will authenticate properly and radius.log says it returns the proper VLAN, but
I am not sure what should happen next - I have followed Network Configuration
Guide for Cisco 3750, but I am not sure if I have configured everything
properly. What is needed for switch to change the VLANs ?
If you need switch configuration, I would gladly send it.
Thanks
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org!
http://sdm.link/slashdot_______________________________________________
PacketFence-users mailing list
[email protected]<mailto:[email protected]>
https://lists.sourceforge.net/lists/listinfo/packetfence-users
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users