> On Apr 7, 2017, at 4:48 AM, Torry, Andrew <[email protected]> wrote:
>
> Pretty sure it uses SNMP to perform a shut/no shut on the interface so make
> sure that is set up correctly.
> I think it can also use SSH access with credentials and the enable password
> if you define it.
>
Sorry Andrew, it does not.
The VLAN is contained in the attributes returned in the RADIUS reply.
Remember that RADIUS takes care of the three "A"s:
* Authentication (is it allowed on the network?)
* Authorization (where should it be allowed, and with which privileges)
* Accounting (how much of a give resource does it use)
If you run freeradius in debug mode you will see the VLAN being returned in an
access-accept packet, typically in the "Tunnel-Private-Group-Id" attribute.
There is no need to involve SNMP or SSH for that.
The only case where PacketFence needs SNMP is when a switch either does not
support RADIUS dynamic assignment at all, or when it does not support RFC 3576
(Dynamic Authorization Extensions to RADIUS), which allows a RADIUS request to
be sent to a NAS in order to e.g. force a disconnection, reauthenticate etc.
That by the way is how we force VLANs to change when a device's registration
status changes (from registered to unregistered or the reverse).
PacketFence sends a RADIUS disconnect or CoA packet to the switch, the switch
issues a new RADIUS request the reply to which will contain the new VLAN.
So when people ask why their VLANs are not changing after registration and they
are stuck behind the captive portal, the answer is almost always because RADIUS
CoA is not enabled on the switch, or there is an ACL preventing the packet from
reaching the switch (either UDP 3799 or 1700 depending on the switch and
firmware).
Googling around for "cisco switch dynamic vlan assignment" brings this up,
which may clarify some things better that I can explain:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_58_se/configuration/guide/2960scg/sw8021x.html#pgfId-1289244
<http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_58_se/configuration/guide/2960scg/sw8021x.html#pgfId-1289244>
Regards,
--
Louis Munro
[email protected] <mailto:[email protected]> :: www.inverse.ca
<http://www.inverse.ca/>
+1.514.447.4918 x125 :: +1 (866) 353-6153 x125
Inverse inc. :: Leaders behind SOGo (www.sogo.nu <http://www.sogo.nu/>) and
PacketFence (www.packetfence.org <http://www.packetfence.org/>)
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users