Hi, all.
I've been trying to make this communication via Infrared work and can't do
it. I'm giving you some more information:
1 - I have installed the Infrared enhancements from 3com to enable this
feature (That wasn't mentioned but I think this is necessary, right ?)
2 - The SerOpen goes OK but when I call the SerSend it return an error that
seems to be HandShakeTimeOut.
3 - The device in the other side receives a lot of garbage although I'm just
trying to send one byte.
4 - I'm not setting any of the controlflow flags so I don't expect the
handshake to try to do anything. I've tried differente speeds (including
below 19200 that should be the threshold to start using handshake), stop
bits, etc.
5 - The device is a Palm III
Can you figure out what I'm missing ?
Thanks in advance,
Eduardo Thuler
Portway
>Hi Ken!
>Ken Wittmer wrote:
>> Essentially, does the Palm have BIOS level calls like MS-DOS?
>Have a look at the usual serial routines.
>Then use them after a
>e = SerControl(refNum, serCtlIrDAEnable, 0, 0);
>that should do what you want. I also use this to communicate with my
>microcontroller-temperaturelogger.
>bexxx
>- --
>"Donuts - is there anything they can't do?"
> Homer J. Simpson
