Hi Byon!
> I have the same problem, plus I get a message about not finding any debug
>nubs about 25% of the time, and often CW causes an unhandled exception error and
>crashes while in debug mode. About 25% of the time everything works fine.
Then you have luck ;-)
My POSE just works "sometimes" under debugging.
I now close POSE & CW before EACH Debug-Session so the Chance is high,
that the prc will be transferred to POSE.
After that I have some instructions for single-step debugging (running
works sometimes fine), then there are timeouts and I set a bp, close CW
again, restart and run to bp.
At the moment, this is what my palm-development slows down.
bexxx
--
"Donuts - is there anything they can't do?"
Homer J. Simpson
