Good try, but no joy.
It is probably something else I have installed somewhere. :-(
Anyone know if you can merge a CWPalm 6.0 with a CWPro 5.3 on a Macintosh? I
saw the earlier postings saying no, but it wasnt clear if that was on a
Windows machine or a Mac or both. I started with a CW Pro 5.3 and merged
the CWPalm 6 into it, and it seemed to work - except for the crashing after
debugging. So, I did a parallel CW Pro 5.0 install and merged the CWPalm
into it - same symptoms.
Unless I hear otherwise I think I will go back to the first setup with 5.3/6
merged
/fn
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Heather
Tufts
Sent: Friday, May 19, 2000 11:02 AM
To: Palm Developer Forum
Subject: Crashing on Mac (was RE: CodeWarrior R6 on Win2000)
Frank,
Go into your system folder:Preferences:Metrowerks, and delete the two
folders labeled CW Debugging Cache and CW Autosave. This should correct
your repeated crashing.
hkmlt
-----Original Message-----
From: Frank Nichols [mailto:[EMAIL PROTECTED]]
Sent: Friday, May 19, 2000 11:05 AM
To: Palm Developer Forum
Subject: RE: CodeWarrior R6 on Win2000
Probably not related, but I am experiencing repeatable frequent crashes
following every debug session using CW R6 with CW Pro 5.0, 5.2, and/or 5.3
on a Macintosh Powerbook G3/400.
/fn
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Magnus
?or Torfason
Sent: Friday, May 19, 2000 9:49 AM
To: Palm Developer Forum
Subject: CodeWarrior R6 on Win2000
I just upgraded:
CW R5 on WinNT -> CW R6 on Win2000
I am having tremendous problems with the debugger,
I have tried three separate ( all clean ) installs of Win2000:
1) It caused the IDE to hang when debugging an application
(For the second time only, first time was OK).
I fixed this by modifying debugger settings.
2) It crashes the IDE if I forget to kill the application
before closing the debugger.
Unresolved.
3) It causes the debugger to hang on breakpoints, instead of
displaying the stack, rendering the debugger essentially
useless. Exiting CW and and reopening it causes the debugger
to behave correctly for a minute or two, then it happens again.
If anyone has similar troubles, i would be glad to
hear some hints or something.
ps. Am I not correct in thinking that Palm has taken over the
support for CodeWarrior. If not, i would appreciate a pointer
to the right channels
Thanks and regards,
Magnus Torfason
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
