I did try with giving some time for detecting incoming calls.It is detecting OK but, the problem that i am facing now is that if somone calls and disconnects before i ignore or receive the call, and tries again, next 4 or 5 calls goes to voice mail. Can someone put light on this ?
Neil Whitworth <[EMAIL PROTECTED]> wrote: Your best bet is probably to just send the data as fast as possible, and accept that for that short period of time incoming voice calls will be diverted to voice mail. If you slow down the rate of transfer, you may increase the chance of the incoming call being received, but the only way to guarantee it is to send no data... Prashant Batra wrote: > So, should I settle down assuming that delay is the only way to get the > notification, in this case ???? > > */Neil Whitworth /* wrote: > > Prashant Batra wrote: > > Hi All, > > > > Here i have a very interesting problem to discuss. > > I have been sending a file to a sever. > > I starts sending file and keep on sending until whole file is > send.But, > > what i have found that it is blocking phone calls. > > If anyone tries to call in between, he gets not reachable message. > > Basically,my set is unable to receive notification for phone call. > > > This is standard behavior on Treo devices. An active data session will > block all incomming voice calls untill it has finished. Likewise an > active voice call will block any attempt to use a data session. the two > are mutually exclusive. > > Note: and active data session means actually transmitting data. Not > just > an open socket. > > > *If i adds delay in the loop, i sometimes get the phone calls but > not > > always.* > > You will receive the voice call if it occurs at just the right time in > the idle data session. If you keep the voice call active for long > enough, your file transfer will probably time out (Depends on protocol > used, ftp/http/etc..) > > > > Can anybody tell me any possible solution for that. > > no :( > > > > > Thanks > > > > > > > > */Cordially/* > > */_Prashant Batra _/* > > > > +91-9891420986 > > > > > ------------------------------------------------------------------------ > > Heres a new way to find what you're looking for - Yahoo! Answers > > > > -- > For information on using the PalmSource Developer Forums, or to > unsubscribe, please see http://www.palmos.com/dev/support/forums/ > > > > > */Cordially/* > */_Prashant Batra _/* > > +91-9891420986 > > ------------------------------------------------------------------------ > Heres a new way to find what you're looking for - Yahoo! Answers > -- For information on using the PalmSource Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/ Cordially Prashant Batra +91-9891420986 --------------------------------- Heres a new way to find what you're looking for - Yahoo! Answers -- For information on using the PalmSource Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
