> <as best as I can recall>
> Go grab a null modem cable and wire your serial ports together
> Set the emulator up for a clean Palm V and serial port 2
> Set the Hotsync software up on serial port 1
> "sync" your emulated device
> Run the Omnisky installer as if your emulator was a real device
>
> When you're all done, make sure "redirect netlib calls to host TCP/IP" is
on,
> then
> SAVE THE EMULATOR SESSION!!!
>
> This was the ONLY way I found to properly debug Omnisky specific INetLib
> problems.
I've had some success debugging against a Visor Prism with the Minstrel S
modem and Omnisky's software using the USB debugger. I've not tried
anything with the Palm V hardware, but your method does seem passable, if
slightly evil. :)
--
Ben Combee
Veriprise Wireless <http://www.veriprise.com>
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
