One drawback I came across with this IR loopback trick (shortcut .t): the receiving "instance" of my application thinks it is active (sysAppLaunchFlagSubCall bit set in the launchFlags), so its normal behavior is to use some globals; alas, these are not really accessible. Is there a way my application is running in IR loopback mode?
-- Luc Le Blanc Dave Lippincott a �crit : > Lookup the developer shortcuts in the Palm Knowledgebase. There is a > shortcut that places the IR port into a loop-back mode and allows you debug > your IR app. It should work on both Pose and a device. > > ----- Original Message ----- > From: "Luc Le Blanc" <[EMAIL PROTECTED]> > Newsgroups: palm-dev-forum > To: "Palm Developer Forum" <[EMAIL PROTECTED]> > Sent: Thursday, September 18, 2003 7:59 AM > Subject: Re: Debugging beaming on IIIxe with CW8.3 > > So, how can I debug beam receive if POSE nor my Palm support it? I send a > 46-bytes AppInfoBloc, followed by 351 ~60-byte records, and on the target > device, the DB I build along receiving those chunks is 84 bytes and 0 > records... > > Can I debug via USB on my Cli� S-360 (Palm OS 4.0)? > > -- > Luc Le Blanc > > Regis St-Gelais a �crit : > > > The Palm III and many other models, uses the same UART to drive the serial > > port and the IR port. It can not use both ports at the same time. > > > > -- > > Regis St-Gelais, P. Eng. / ing. > > Software Development / D�veloppement informatique > > Technical Support / Support technique > > Laubrass inc. > > www.laubrass.com > > [EMAIL PROTECTED] > > (remove / enlever 'NOSPAM') > > -- > > "Luc Le Blanc" <[EMAIL PROTECTED]> a �crit dans le message de > > news:[EMAIL PROTECTED] > > > > I'm trying to debug beaming on my IIIxe hooked to CW 8.3 via a serial > > port. I launch my application with a normal launch code, and then I > > start beaming to it with a Cli�. The Cli� keeps searching for a > > destination device, but the IIIxe in its cradle doesn't react to the > > beam. Yet, the same operation outside debugging works. I tried launching > > my application with a AskUser or Receive launch code, with no better > > results. What's the trick? > > -- > For information on using the Palm Developer Forums, or to unsubscribe, > please see http://www.palmos.com/dev/support/forums/ -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
