Ben Combee a écrit : > At 10:41 PM 1/5/2004, Luc Le Blanc wrote: > >I run CW 8.3. Regularly, I quit a debug session with set breakpoints. If I > >start another debug session with the same PRC, previous breakpoints > >remain, but > >I cannot go beyond the first one I hit, the blue arrow sticks onto it and > >control hangs. Deleting all breakpoints usually doesn't do any good: running a > >new debug session still stops and hangs at the previous breakpoints. Was this > >solved in CW 9.2? > > I don't remember this bug being reported in 8.3, and I've not seen similar > behavior in any of the 9.x builds. > > When you say "quit a debug session", are you working with POSE, PalmSim, or > a device?
POSE. I use the Debug->Kill menu item in CW IDE to stop and reset POSE if not already triggered by CW. > There are potential problems with ending a session with POSE and > having it set to "save your state", as that could save PRCs with embedded > breakpoints. This is one of the big reasons that V9 has POSE start/stop > support, where POSE is killed at the end of the debug session, making sure > that when it starts back up, the session will be clean. Could be it. -- Luc Le Blanc -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/