Scott Rock wrote:
I have successfully gotten the program working using John's advice above. While it isn't too clean, it works. But this has brought about another question...
Currently my app sets an alarm for 2 seconds, switches to the Garmin program, then after the 2 seconds my program starts with the command sysAppLaunchCmdAlarmTriggered. It adds a purgeAlarm to keep the sysAppLaunchCmdDisplayAlarm from happening. On a sysAppLaunchCmdAlarmTriggered command, I check the current location and if it isn't at an intended location, it sets another 2 second alarm and switches back to the Garmin app. So as you can see, it's a continuous loop until the location is found.
Here's the problem. If the correct location is not found, I see the Garmin application and then every 2 seconds (when my alarm is triggering), the screen goes grey for a very brief instant, and then the Garmin app shows again. Is there any way to keep the screen from temporarily going grey while my program is processing the location?
I thought my program may have been temporarily trying to display a form, so as a check, I made the trigger command only set the alarm and switch to the Garmin app (thus no processing in my program). This didn't help at all---the screen still goes grey every 2 seconds.
Any ideas anyone?
Thanks, Scott
Use a ProcedureAlarm.
Regards, Henk -- ------------------------------------------------------------------------- Henk Jonas [EMAIL PROTECTED] Palm OS Â certified developer
Please contact me, if you need an off-side contract worker. -------------------------------------------------------------------------
-- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
