On 12/8/06, Guilherme C. Hazan <[EMAIL PROTECTED]> wrote:
ok, was a problem when the mem semaphore. now i can open and it doesnt freezes, but only trash is received...
SIR works flawlessly on xscale based ARM devices. IRCOMM is required if you are going to use any device with an OMAP processor; the controller used for serial communication is hardwired only to support IRCOMM. its not a standard serial interface. i am pretty sure this has been discussed quite a bit in the past. http://news.palmos.com/read/messages?id=146145#146145 http://news.palmos.com/read/messages?id=149456#149456 go here: http://www.alanjmcf.me.uk/comms/infrared/IrDA%20FAQ.html look down at topic #20, i quote: "Raw IR mode cannot be used on OMAP-based (Tungsten|T, Tungsten|T2, Tungsten|E, Zire21, Treo600, and Zire71) products due to an OMAP processor limitation. The OMAP's UART3 automatically frames all data according to the IrDA specification. There is no way to change this setting in the processor and use raw IR in the OMAP UART." fun hey? :) -- // Aaron Ardiri -- For information on using the PalmSource Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
