JoeG
-----Original Message-----
From: [email protected]
To: [email protected]
Sent: Wed, Aug 19, 2009 7:59 pm
Subject: [Papermodels II 39506] Assembly trick
-----Original Message-----
From: [email protected]
To: [email protected]
Sent: Wed, Aug 19, 2009 7:59 pm
Subject: [Papermodels II 39506] Assembly trick
Here is a technique I use when, due to an out of sequence assembly, it is necessary to have a backing to press against.
In this case the truck cab has been closed up and I am adding the windshield. A strong straight wire
makes a tiny hole in the bottom panel, slides through and allows positioning and pressure to be applied
against the roof tab behind the windshield (white arrow).
Hope this helps,
Bob Penikas
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Papermodels II" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [email protected]
For more options, visit this group at http://groups.google.com/group/papermodels?hl=en
-~----------~----~----~----~------~----~------~--~---
In this case the truck cab has been closed up and I am adding the windshield. A strong straight wire
makes a tiny hole in the bottom panel, slides through and allows positioning and pressure to be applied
against the roof tab behind the windshield (white arrow).
Hope this helps,
Bob Penikas
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Papermodels II" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [email protected]
For more options, visit this group at http://groups.google.com/group/papermodels?hl=en
-~----------~----~----~----~------~----~------~--~---
