Hi, The current STL reader has no debug information to tell you why it failed to read a file. If you are able to send me the file I can look into why the reader fails.
On Mon, May 30, 2011 at 9:47 AM, Michael Jackson < [email protected]> wrote: > I am creating an STL Binary file from another program. I am then trying to > load it in ParaView. ParaView seems to recognize the STL file but after I > load it nothing appears. I click on the "Information" tab and it says > Polygonal Mesh but 0 cells and 0 points. There are no error messages or > anything else. Is there something I can enable to try and figure out why > nothing is showing up or the read is failing? > > Thanks > ___________________________________________________________ > Mike Jackson www.bluequartz.net > Principal Software Engineer [email protected] > BlueQuartz Software Dayton, Ohio > > > > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > Follow this link to subscribe/unsubscribe: > http://www.paraview.org/mailman/listinfo/paraview > -- Robert Maynard
_______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
