Excellent, I was just going to look at why the file was failing :) On Mon, May 30, 2011 at 10:33 AM, Michael Jackson < [email protected]> wrote:
> Figured it out. The issue was obviously in my writer. I was not offsetting > into the file correctly to write the data which lead ParaView to basically > just read junk data would be my guess and could not interpret it. > ___________________________________________________________ > Mike Jackson www.bluequartz.net > Principal Software Engineer [email protected] > BlueQuartz Software Dayton, Ohio > > > > On May 30, 2011, at 9:57 AM, Robert Maynard wrote: > > > Hi, > > > > The current STL reader has no debug information to tell you why it failed > to read a file. If you are able to send me the file I can look into why the > reader fails. > > > > On Mon, May 30, 2011 at 9:47 AM, Michael Jackson < > [email protected]> wrote: > > I am creating an STL Binary file from another program. I am then trying > to load it in ParaView. ParaView seems to recognize the STL file but after I > load it nothing appears. I click on the "Information" tab and it says > Polygonal Mesh but 0 cells and 0 points. There are no error messages or > anything else. Is there something I can enable to try and figure out why > nothing is showing up or the read is failing? > > > > Thanks > > ___________________________________________________________ > > Mike Jackson www.bluequartz.net > > Principal Software Engineer [email protected] > > BlueQuartz Software Dayton, Ohio > > > > > > > > _______________________________________________ > > Powered by www.kitware.com > > > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > > > Follow this link to subscribe/unsubscribe: > > http://www.paraview.org/mailman/listinfo/paraview > > > > > > > > -- > > Robert Maynard > > -- Robert Maynard
_______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
