As scripted by Mr. Rath:
> I > have a XLR8 MACh G3 ZIF Carrier Card, and a 233 ZIF. I have set the switches > to 6,7,8,9 and can't find (or figure out where) the jumpers are they refer > to on their web site. The card is going in a 7500 power mac, when the card > goes in the machine powers up and the drive whir's but the machine will not > give the start up tone nor will it boot - at all. Pull the ZIF Carrier card, > put the 604e/200 card back in and all is fine. More than likely your problem is one of two things. The jumpers are not set correctly or you didn't cuda. You NEED to reset the motherboard when installing this card. Go to http://www.xlr8.com and check your jumper (switch) settings.... -- Tim 1st/pci-pm list nanny [EMAIL PROTECTED] -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
