Janice, Termination is supposed to only be on the last drive on the SCSI bus (physically). It is supposed to be removed from all others on that bus. You really need to get a copy of the jumper setup from the vendor. That information is usually available from the manufacturer on their web site under support. Does the computer boot with either drive?
It is possible to have ruined the internal SCSI bus if both drives had termination enabled at the same time, and both hooked up to the same bus. I found this out on my 7600, when the computer would boot up with a drive hooked up to the external bus, but not the internal bus. (at least that's how I think my internal SCSI bus got damaged) I would check the setup on the original drive (ID, termination, etc) and see if the computer boots up. If not, see if it will boot up hooked to the external bus. STeve -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
