>> >> Does anyone know what switch settings are required to use an >> XLR8 Carrier w/Powerforce G3 450/1MB ZIF in a PM7500. >> >> I have tried over thirty different settings from the XLR8 charts. >> I can not get it to run over 300 MHz with a bus speed of 38 MHz.
On 11/29/02 12:49 PM, "James S Jones" <[EMAIL PROTECTED]> wrote: > I don't have a chart in front of me to give specific suggestions, but > there is page at OWC to explain how to use it: > > <http://eshop.macsales.com/Tech/Load_Page.cfm?page=xlr8carriercard.html> > > Evidently, all you need is to know your bus speed (50 MHz) and the > processor speed, line those up, and you have the DIP settings. > > On Friday, November 29, 2002, at 08:15 AM, Brian A. Rein wrote: > Those instructions do not apply. There is no chart on page 72 in my manual. I have used the chart on XLR8's site and those in the manual. Brian -- -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
