Hi all, Just wondering if anyone else had experienced these problems:
I just put a Sonnet G3/500 into my Power Tower Pro 225. I also upgraded to 9.2.2 via OS 9 Helper. I am experiencing printing problems. (these occured before the 9.2.2 upgrade but after the installation of the G3 card) My printers are a Canon s600 USB and I have my Laserwriter Select connected to a serial hub, which I also have a Stylewriter 2400 attached. I have 768megs of ram. I am getting an M306 error when I print from my Canon USB . It prints part of the page sometimes and then it get a communication error . My Laserwriter comes up with a "please check the connection" also. I am also experiencing strange start up problems. Actually I can start up from a cold start ok, but I can not restart. Most of the time when I restart, I get a short bit of the startup chime and then nothing. I then shut the computer off, let it sit a minute and all is fine. I have cleared the pram with techtools pro, but I cannot zap the pram or I get the same short chime and nothing...... Any help or ideas would be greatly appreciated ....... Thanks, pam -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
