Only PC66 RAM shall run on this board.
----- Original Message -----
From: "Mark Fraleigh" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, July 29, 2001 10:06 PM
Subject: PCWorks: Metherboard and Ram???
: Hi everyone,
: As usual I need some of your expert advice. I have an older computer that
: I would like to add ram to. It is an intel 166mhz mmx processor with a Pine
: 586 Mb w/triton Edo. The part number for the motherboard is PT-7502-2
: 430vx system board. From the manual I have it shows 4 slots (2 banks)
: 72-pin Simm slots for fast page or EDO DRam and also has 2 168-pin Dimm
: sockets for EDo or SDram modules. Maximum memory cannot exceed 128 MB in
: any combination according to the manual. As far as I can tell from the
: manual the CPU Input Clock speed is 66MHz. I would like to know if I could
: use PC-100 or PC-133 ram or do I have to use PC-66 ram. Will different
: types of ram harm the computer. The manual suggests different MB
: combinations to use with SIMMs and DIMMs but not exactally which type can
: be used.I would like to end up with 128MB ram when finished.I would
: appreciate any and all comments. Thanking you all in advance. If any more
: info is needed please e-mail me, [EMAIL PROTECTED] Thanks again.
:
: Mark
============= PCWorks Mailing List =================
Don't see your post? Check our posting guidelines &
make sure you've followed proper posting procedures,
http://pcworkers.com/rules.htm
Contact list owner <[EMAIL PROTECTED]>
Unsubscribing and other changes: http://pcworkers.com
=====================================================
